Seven resin cut-off discs for compatible rotary tools and tested cutting tasks on suitable project materials
Description
This Wagtail set includes seven resin cutting discs as shown. They are intended for suitable light cutting, grooving, or trimming only when the disc, arbor or mandrel, tool, speed, guard, workpiece, and material are compatible. Cutting behaviour and finish depend on disc condition, pressure, direction, material, and equipment settings.
Key features
- Seven resin cut-off discs included.
- Thin disc format as shown; exact thickness, diameter, bore, and rating should be checked against the supplied pack before use.
- Suitable only for compatible rotary tools, drills, or grinders with the correct mandrel or arbor.
- Suitable project materials may include tested metal, wood, plastic, veneer, or other materials only when the disc and tool instructions permit.
- Approximate listed package dimensions: 13 cm length × 8 cm width × 0 cm height; package weight was not stated in the source listing.
- 1 set of 7 cutting discs included.
Tool, disc, and safety notes
- Confirm disc diameter, thickness, centre hole, arbor/mandrel fit, tool instructions, disc material, maximum speed, and permitted materials before use. Do not assume compatibility with every drill, rotary tool, or grinder.
- Use the manufacturer-approved guard or protective enclosure where required. Never operate a disc that is cracked, chipped, bent, damp, contaminated, expired, or otherwise damaged.
- Disconnect power or remove the battery before changing a disc or mandrel. Install the disc in the correct orientation, tighten properly, and check for wobble or looseness before starting.
- Secure the workpiece and wear suitable eye and face protection, hearing protection, gloves appropriate to the task, and respiratory protection where dust or coating particles may occur. Keep hands, hair, clothing, cords, and bystanders clear.
- Start at a compatible speed with light, controlled pressure. Do not force the disc, side-load it, twist it in the cut, stall the tool, or make sudden contact; these actions can cause heat, kickback, or disc breakage.
- Cutting can create sparks, hot fragments, dust, sharp edges, and heat. Keep flammable liquids, fuel, gas, wood dust, chemicals, and ignition-sensitive materials away from the work area.
- Test the disc and technique on scrap or an inconspicuous area first. The disc may remove material, alter dimensions, burn or melt plastic/wood, damage coatings, or leave a rough or discoloured edge.
- Do not assume the set cuts ceramics, glass, stone, hardened materials, sheet metal, or any other material unless specifically rated and instructed for that use.
- Stop if the disc vibrates, binds, smokes, sparks unexpectedly, overheats, chips, or produces unusual noise or odour. Switch off, isolate the tool, and allow components to cool before inspection.
- Do not use on skin, teeth, food, medical devices, live electrical parts, or applications requiring certified abrasive or machine-guarding equipment.
- Store discs flat, dry, and supported away from moisture, direct heat, bending, chemicals, children, and pets. Dispose of worn or broken discs according to local waste guidance; do not burn them.
- Disc life, cutting speed, heat generation, finish, and material range vary; no clean-cut, low-heat, professional-grade, universal, or tool-life result is guaranteed.
Specifications
-
Type: Resin cut-off disc set
-
Quantity: 7 pieces
-
Material: Resin as listed
-
Mounting: Requires a compatible mandrel or arbor; confirm centre-hole and tool fit
-
Dimensions: Package dimensions listed as approximately 13 cm × 8 cm; height not reliably stated
-
Use: Suitable compatible cutting, grooving, or trimming on tested project materials
-
Package contents: 7 resin cutting discs; mandrel/tool not confirmed as included
